JournalTOCs

Journal of Solar Energy
Number of Followers: 12

This is an Open Access Journal

Open Access journal
ISSN (Online) 2314-6230
Published by Hindawi

[340 journals]

Dynamic Modeling and Simulation of an Isolated Hybrid Power System in a
Rural Area of China
- Abstract: In some rural areas in the northwest of China, people are suffering from not only the voltage drop due to long distance transmission but also the power outages due to remoteness and poorly maintained grid. In recent few years, the price of solar energy has been reduced drastically every year in China due to the government policy on renewable energy. In the near future, isolated hybrid power systems for home use could be affordable and used by residences in these rural areas. Thus, it is necessary to design a hybrid power system based on local load and weather condition to check system feasibility and expected performance. It includes load simulation, system sizing, and dynamic system modeling and simulation. This paper firstly introduces current development of renewable energy in China and then goes through the sizing, modeling, and simulation of the system design for a typical remote home in China and finally discusses the system’s availability based on the simulation results. In this paper, the NASA website is the source for weather data, and BEopt is used to generate load data. During system modeling, the MPPT algorithm is much simpler designed than the complex incremental method. A soft starter is adopted with the diesel generator for stability. The charge controller of the battery storage provides external command to the MPPT and diesel PID controller to prevent the battery storage from overcharging. The rms value of the fundamental load voltage is used in the voltage control loop of the inverter.
  PubDate: Sun, 03 Jun 2018 00:00:00 +000
Low-Cost SCADA System Using Arduino and Reliance SCADA for a Stand-Alone
Photovoltaic System
- Abstract: SCADA (supervisory control and data acquisition) systems are currently employed in many applications, such as home automation, greenhouse automation, and hybrid power systems. Commercial SCADA systems are costly to set up and maintain; therefore those are not used for small renewable energy systems. This paper demonstrates applying Reliance SCADA and Arduino Uno on a small photovoltaic (PV) power system to monitor the PV current, voltage, and battery, as well as efficiency. The designed system uses low-cost sensors, an Arduino Uno microcontroller, and free Reliance SCADA software. The Arduino Uno microcontroller collects data from sensors and communicates with a computer through a USB cable. Uno has been programmed to transmit data to Reliance SCADA on PC. In addition, Modbus library has been uploaded on Arduino to allow communication between the Arduino and our SCADA system by using MODBUS RTU protocol. The results of the experiments demonstrate that SCADA works in real time and can be effectively used in monitoring a solar energy system.
  PubDate: Wed, 02 May 2018 00:00:00 +000
Dynamic Modelling of a Solar Water Pumping System with Energy Storage
- Abstract: This paper describes the dynamic modelling of a system used for extraction of groundwater for irrigation using an alternative source of energy. The system is designed based on data of an existing project in Lalmonirhat, Bangladesh. The system comprises a 38.4 kWp solar photovoltaic array, inverter, AC motor, and pump set, which can discharge a maximum of 1,930 m3 of water per day. MATLAB simulation is performed with two types of energy storage system: (i) electric energy using a battery bank and (ii) stored water in a large water tank. A large battery bank and a transformer are needed in the former one, which turns out as a costly solution. The latter one requires a boost converter and a large water tank to store around 2,000 m3 of water, which is also a costly solution. A combination of both systems yields an efficient and economical solution. The effectiveness of these three systems is compared with conventional diesel engine system.
  PubDate: Sun, 08 Apr 2018 00:00:00 +000
Optimization of Solar Energy Harvesting: An Empirical Approach
- Abstract: Renewable energy is the path for a sustainable future. The development in this field is progressing rapidly and solar energy is at the heart of this development. The performance and efficiency limitations are the main obstacles preventing solar energy from fulfilling its potential. This research intends to improve the performance of solar panels by identifying and optimizing the affecting factors. For this purpose, a mechanical system was developed to hold and control the tilt and orientation of the photovoltaic panel. A data acquisition system and electrical system were built to measure and store performance data of the photovoltaic panels. A design of experiments and Response Surface Methodology were used to investigate the impact of these factors on the yield response as well as the output optimization. The findings of the experiment showed an optimum result with a tilt of 60° from the horizon, an azimuth angel of 45° from the south, and a clean panel condition. The wind factor showed insignificant impact within the specified range.
  PubDate: Sun, 01 Apr 2018 00:00:00 +000
Output-Feedback Nonlinear Adaptive Control Strategy of the Single-Phase
Grid-Connected Photovoltaic System
- Abstract: This paper addresses the problem of controlling the single-phase grid connected to the photovoltaic system through a full bridge inverter with LCL-filter. The control aims are threefold: (i) imposing the voltage in the output of PV panel to track a reference provided by the MPPT block; (ii) regulating the DC-link voltage to guarantee the power exchange between the source and AC grid; (iii) ensuring a satisfactory power factor correction (PFC). The problem is dealt with using a cascade nonlinear adaptive controller that is developed making use of sliding-mode technique and observers in order to estimate the state variables and grid parameters, by measuring only the grid current, PV voltage, and the DC bus voltage. The control problem addressed by this work involves several difficulties, including the uncertainty of some parameters of the system and the numerous state variables are inaccessible to measurements. The results are confirmed by simulation under MATLAB∖Simulink∖SimPowerSystems, which show that the proposed regulator is robust with respect to climate changes.
  PubDate: Thu, 08 Mar 2018 06:25:45 +000